Pulse Width Modulation - Pwm - YASKAWA CPU 013C Manual

Configuration with VIPA SPEED7 Studio
Deployment I/O periphery > Pulse width modulation - PWM
Parameter overview
Operating parameters
Integration time
max. counting frequency...
Hardware interrupt
End of measurement

9.6.7 Pulse width modulation - PWM

9.6.7.1 Overview
9.6.7.2 Parametrization in SPEED7 Studio
9.6.7.2.1 'I/O addresses'
Sub module Input address
Count 816
820
824
828
Sub module Output address
Count 816
820
824
828
9.6.7.2.2 'Channel x'
Operating mode
212
Description
Specify the integration time
Range of values: 10ms ... 10000ms in steps of 1ms
Specify the max. Frequency for the corresponding input
Range of values: 1, 2, 5, 10, 30, 60, 100kHz
Description
Hardware interrupt at end of measurement
n 2 channels
n Sub module 'Counter'
Ä Chapter 5.8 'Pulse width modulation - PWM' on page 137
n
Access
DINT
DINT
DINT
DINT
Access
DWORD
DWORD
DWORD
DWORD
Select via 'Channel' the channel and select for pulse width modulation via 'Operating
mode' the operating mode 'Pulse width modulation' . Default values and structure of this
dialog box depend on the selected 'Operating mode' . The following parameters are sup-
ported:
Assignment
reserved
reserved
reserved
reserved
Assignment
reserved
reserved
reserved
reserved
HB300 | CPU | 013-CCF0R00 | en | 16-40
VIPA System SLIO
Assignment
100ms
60kHz
Assignment
de-activated