Table of Contents
Advertisement
Deployment CPU 013-CCF0R00
Accessing the web server > Web page with selected CPU
4.10
Accessing the web server
4.10.1
Access via the Ethernet PG/OP channel
4.10.2
Structure of the web page
4.10.3
Web page with selected CPU
74
3.
Copy the blocks from the project blocks folder and the System data into the wld file.
4.
Copy the wld file at a suited memory card. Plug this into your CPU and start it
again.
ð The transfer of the application program from the memory card into the CPU
takes place depending on the file name after an overall reset or PowerON.
S7PROG.WLD is read from the memory card after overall reset.
AUTOLOAD.WLD is read from the memory card after PowerON.
The blinking of the SD LED of the CPU marks the active transfer. Please regard
that your user memory serves for enough space for your user program, other-
wise your user program is not completely loaded and the SF LED gets on.
There is a web server, which can be accessed via the IP address of the Ethernet PG/OP
channel with an Internet browser. At the web page information about the CPU and its
connected modules can be found.
PG/OP channel' on page 64
It is assumed that there is a connection between PC and CPU with Internet browser via
the Ethernet PG/OP channel. This may be tested by Ping to the IP address of the
Ethernet PG/OP channel.
The web page is built dynamically and depends on the number of modules, which are
connected to the CPU. The web page only shows information. The shown values cannot
be changed
Please consider the System SLIO power and clamp modules do not have
any module ID. These may not be recognized by the CPU and so are not
listed and considered during slot allocation.
Ä Chapter 4.6 'Hardware configuration - Ethernet
HB300 | CPU | 013-CCF0R00 | en | 16-40
VIPA System SLIO
Advertisement
Table of Contents
