Wiring; Wiring Cpu - YASKAWA VIPA System MICRO M13-CCF0000 Manual

Basics and mounting
Wiring > Wiring CPU

2.5 Wiring

2.5.1 Wiring CPU

CPU connector
Data
Wiring procedure
18
CAUTION!
Consider temperature for external cables!
Cables may experience temperature increase due to system heat dissi-
pation. Thus the cabling specification must be chosen 5°C above ambient
temperature!
CAUTION!
Separate insulation areas!
The system is specified for SELV/PELV environment. Devices, which are
attached to the system must meet theses specifications. Installation and
cable routing other than SELV/PELV specification must be separated
from the system's equipment!
For wiring the CPU has removable connectors. With the wiring of the connectors a "push-
in" spring-clip technique is used. This allows a quick and easy connection of your signal
and supply lines. The clamping off takes place by means of a screwdriver.
U 240V AC / 30V DC
max
I 10A
max
Cross section
0.2 ... 1.5mm
Stripping length 10mm
Use for wiring rigid wires respectively use wire sleeves. When using stranded wires you
have to press the release button with a screwdriver during the wiring.
1 Labeling on the casing
2 Pin no. at the connector
3 Release area
4 Connection hole for wire
2 (AWG 24 ... 16)
HB400 | CPU | M13-CCF0000 | en | 16-47
VIPA System MICRO