Flexible Setup For Room Status - NEC Univerge SV8100 Programming Manual

UNIVERGE SV8100
Level:
IN
Description
(This program is aviable for V7000 or higher)
Use Program 42-07 : Flexible Setup for Room Status to enable dial room status
codes. Note the code definitions only apply to the system itself. When sending room
status messages to the PMS Application, the status codes are always sent as defined
in the PMS Developer Guide.
For example, if in PRG 42-09-01 status code 1 is set to Inspection Required. The
PMS Developer Guide defines "Inspection Required" as status message number 4. If
in the SV8100 room status 1 is assigned to a room the PVA PMS interface will send
status message number 4 to the PMS Application. If nothing is assigned in
PRG 42-09-01 the default room status codes are sent as defined in the PMS
Developer Guide.
Input Data
Item
No.
01
Programming Manual

42-09 : Flexible Setup for Room Status

Room Status Number
Item
Flexible Setup for Room Status
Conditions
None
Program 42 : Hotel Setup
1,2,3,4,5,6,7,8,9,0,#,
Input Data
1 = Room Clean (Occupied)
2 = Maid Required
3 = Maid in Room
4 = Inspection Required
5 = Maintenance Request
6 = Out of order
7 = Reserve 1
8 = Reserve 2
9 = Reserve 3
0 = Room Clean (Vacant)
= Reserve 5

# = Reserve 6
Issue 10.1

Default
0
2 - 529