NEC Univerge SV8100 Programming Manual page 193

UNIVERGE SV8100
Item
No.
06
07
08
09
10
11
12
Programming Manual
Item
Pause at 1st Digit after Line Seize in
Manual Dial Mode
DP to DTMF Conversion Options
Determine how a user can convert a
Dial Pulse (DP) call to a DTMF call. For
each trunk, set the type of DP to DTMF
conversion required. There are three
conversion options: Automatic (0),
Automatic and Manual (1), or Manual
(2).
Automatic:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit. In addition, the
user can dial to switch a DP trunk to
#
DTMF dialing.
Manual:
Users can dial to switch a DP trunk
#
to DTMF dialing.
Answering Condition
Busy Tone Detection
Caller ID
Enable or disable a trunk ability to
receive Caller ID information.
Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the
system ability to skip over a trunk if dial
tone is not detected. This option
pertains to calls placed using Speed
Dial, ARS, Last Number Redial or
Save Number dialed. It does not
pertain to line key or Direct Trunk
Access calls.
Detect Network Disconnect Signal
Input Data
0 = No Pause (No)
1 = Pause (Yes)
0 = Automatic
1 = Automatic and
Manual
2 = Manual
0 = Polarity
Reversing
(Polarity)
1 = Polarity
Reversing or
Timer (Int Digit)
0 = Disable (No)
1 = Enable (Yes)
0 = No
1 = Yes
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
Issue 10.1
Related
Default
Program
1 21-01-06
2 21-01-03
1 21-01-03
0 (OT)
1 (AU)
0 (OT)
1 (AU)
0
0
2 - 157