Sip Server Information Setup - NEC Univerge SV8100 Programming Manual

UNIVERGE SV8100
Program 10 : System Configuration Setup
Level:
SA
Description
Use Program 10-29 : SIP Server Information Setup to define the SIP Proxy setup
for outbound/inbound. The 10-29 commands are not used in non-registration mode.

Input Data
Item
No.
Programming Manual
If entries are made in Program 10-29-xx for a SIP Server and the SIP Server is then removed or
not used, the entries in Program 10-29-xx must be set back to their default settings. Even if
10-29-01 is set to 0 (off), the SV8100 still checks the settings in the remaining 10-29 programs.
Item
01
Default Proxy (Outbound)
This sets whether the SIP message is
always sent through the Default Proxy.
02
Default Proxy (Inbound)
Need to be registered in registration mode.
This sets whether the SIP message is
always received through the Default Proxy.
03
Default Proxy IP Address
This is optional and used if the provider
gives you a proxy address that is different
than the registration address. If the
provider is using domain names instead of
IP addresses, leave this at default.
04
Default Proxy Port Number
The port number of the Default Proxy is set.
05
Registrar Mode
The mode registered in the registration
server is set.
06
Registrar IP Address
IP address of the SIP registration server is
set.
07
Registrar Port Number
The port number of the SIP registration
server is set.

10-29 : SIP Server Information Setup

0 = Off
1 = On
0 = Off
1 = On
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0 ~ 65535
0 = None
1 = Manual
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0 ~ 65535
Issue 10.1
Input Data Default
0
0
0.0.0.0
5060
0
0.0.0.0
5060
2 - 49