NEC Univerge SV8100 Programming Manual page 394

Issue 10.1
Item
No.
05
06
07
08
09
10
11
13
2 - 358
Item
Transfer Destination Number 1
Transfer Destination Number 2
400 - Allow the outside party to dial a
different extension number in the
translation table (for example, ring no
answer to a dialed number, the caller then
hears a dial tone, allowing them to enter
another Valid Extension Number).
401 - Provide the caller with DISA dialing
options (requires using the DISA
password).
 This applies to 22-11-05 and
22-11-06.
Call Waiting
PRG 20-09-07 overrides this setting.
Maximum Number of DID Calls
Music on Hold Source
ACI Music Source Port
Ring Group Transfer
Enable (1) or disable (0) each
conversation tables ability to follow the
Ring Group programming defined in
Program 22-12-01: DID Intercept Ring
Group.
If Program 22-11-05: DID Translation
Number Conversion, Transfer Destination
Number 1 and Program 22-11-06: DID
Translation Number Conversion, Transfer
Destination Number 2 are set, the priority
of transferring is in this order: Program
22-11-05 then Program 22-11-06 then if
Program 22-11-11 is enabled, Program
22-12-01.
Identify for Mobile Extension
When set '1 = On' system can identify
incoming Dial-in number for Mobile
extension call or normal Dial-in number
per each Dial-in number base.
Related: PRG13-04-01, PRG15-22-01
Input Data
0 = No Setting
1~100 = Incoming Group
102 = In-Skin/External Voice Mail
or InMail
103 = Centralized VM
201~264 = Extension Group
400 = Valid Extension Number
401 = DISA
501~599 = DISA/VRS Message
1000~1999 = Speed Dial Number
(000~999)
0 = Disable (No)
1 = Enable (Yes)
0~200 (0 = No Limit)
0 = IC/MOH Port
1 = BGM Port
2 = ACI Port
When a sound source type is 2 in
above: (0~96)
0 = Disable (Caller will hear
Ringback)
1 = Enabled (Go to normal ring)
0 = Off
1 = On
Program 22 : Incoming Call Setup
UNIVERGE SV8100
Default
0
0
0
0
0
0
1 (OT)
0 (AU)
0