NEC Univerge SV8100 Programming Manual page 905

UNIVERGE SV8100
Alarm
Type Report
No.
3 0 Connection
2
fault between
CD-CP00 and
other PKGs.
4 0 PKG S/W
2
Download
Error
5 0 Cooling fan
1
error
Programming Manual
Table 2-20 Description of Alarm (Continued)
Name Content of Alarm
The error occurred when
communicating with the
package. When the
package is broken, it
recognizes it as a
communication fault.
The unit program could not
be downloaded normally.
The unit could not able to
be started normally.
The cooling fan does not
work normally.
Cause Action
1.The unit is not 1.Please insert the unit
completely firmly.
inserted. 2.The power-supply
2.The power- voltage must use
supply voltage of another power supply
the system is when is in the range of
outside ratings. ratings or measuring
3.The equipment with the voltmeter, and
that generates the deviating from the rated
noise in the same
range.
power supply 3.Please use the power
system as the supply besides the
power supply origin equipment with the
of the system is possibility of the noise
connected, and it source.
malfunctions 4.Please separate as
because of the much as possible and
power supply use a main device from
noise. the equipment by which
4.The equipment to you seem may
which it is adjacent generate the radiation
to of a main device, noise.
and has put out the 5.Please ground the
radiation noise chassis correctly.
exists, and it
malfunctions
because of the
radiation noise.
5.The chassis is
not properly
grounded.
1.The package 1.Delete slot
software is not information that
stored in the corresponds by
downloaded USB PRG90-05-01 to delete
memory. package information
2.The stored that was installed
package software before.
is illegal. 2.There is a possibility
Package that the unit program is
information that broken though an
was installed external factor of the
before remains. noise etc. is thought.
3.Please load into the
USB memory and try
again when you back
up the unit program.
4.PleaseCheck with
maker on uncertain
points.
1.The cooling fan 1.Confirm the cooling
has stopped fan is turning.
working.
2.Verify the cooling fan
2.The cooling fan mounting.
has come off.
Issue 10.1
Alarm
Recovery
Status
When unit is ERR
confirmed, the
REC
error is
recovered.
Please ERR
exchange
REC
units, though
it is likely to
restore by
mounting the
unit again.
When the unit
program is
normally
downloaded,
the error is
recovered.
Replace the
cooling fan if it
is defective.
2 - 869