90-05: Slot Control - NEC Univerge SV8100 Programming Manual

Issue 10.1
Level:
IN
Description
(This program is available via telephone programming and Web Programming, but
not through PC Programming).
Use Program 90-05: Slot Control to reset or delete (uninstall) blades (slots 1~24).
Delete allows you to completely uninstall the blade. You should do this if you want to
remove a blade and plug it into a different slot and still retain the port assignments. If
a different type of interface blade is being installed in a slot previously used (e.g.,
changing from a LCA to an DLCA blade), the slot should be deleted (option 1) first
before installing the new interface blade.
Reset allows you to send a reset code.
Input Data
Input Data
Item
2 - 862
Program 90 : Maintenance Program
System ID
Menu Number
Item
No.
01
Slot Control
Conditions
When you delete or reset a blade, you must first remove it from its slot then run

Program 90-05. When reusing the slot for another blade, you must plug the blade
in or reset the system before the system can use the slot again.
When you delete or reset a blade, all related programming in Program 10-03-01 is

set back to default.
Input Data
Slot Number (0~24 0 = No Setting)
Program 90 : Maintenance Program
UNIVERGE SV8100

90-05: Slot Control

00 - 50
1 = Delete
2 = Reset
3 = Set Busy Out
4 = Reset Busy Out