NEC Univerge SV8100 Programming Manual page 84

Issue 10.1
Input Data
Feature Cross Reference
None
2 - 48
06
IP Trunk Port Binding
Trunk port binding is only used for
SIP trunks to the provider in Non-
Registration Mode only. When this
is disabled, an inbound call comes
in and follows your DID routing but
it comes in on the first available
trunk. When enabled, the inbound
call comes in and follows your
normal DID routing but maps to
that specified trunk. If that trunk is
busy, it sends back a busy unless
you build a hunt group. To build
the hunt group, it references
command 14-12-02 (pilot register
ID). This then points you to
command 10-36-02. All the
numbers with the same pilot are in
the same hunt group.
Conditions
None
0 = Disable
1 = Enable
Program 10 : System Configuration Setup
UNIVERGE SV8100
0