NEC Univerge SV8100 Programming Manual page 506

Issue 10.1
Item
No.
2 - 470
07
Toll Charge Cost
Set this option to (1) have the SMDR report include
toll charges.
08
Incoming Call
Enable this option (1) to have the SMDR report
include incoming calls. If you disable this option (0),
incoming calls do not print.
09
Extension Number or Name
Set this option (1) to have the SMDR report include
extension numbers. Set this option (0) to have the
SMDR report include extension names.
10
All Lines Busy (ALB) Output
Determine if the All Lines Busy (ALB) indication
should be displayed.
11
Walking Toll Restriction Table Number
12
DID Table Name Output
Determine if the DID table name should be
displayed.
13
CLI Output When DID to Trunk
Determine if the CLI output should be displayed for
DID.
14
Date
Determine whether or not the date should be
displayed on SMDR reports.

This option must be set to 0 if the trunk name is
set to be displayed in Program 35-02-03.
15
CLI/DID Number Switching
Determine whether or not the CLI/DID Number
Switching should be displayed.
16
Trunk Name or Received Dialed Number
Determine how the SMDR should print incoming calls
on ANI/DNIS or DID trunks. If set to (1), ANI/DNIS
trunks can print DNIS digits. If set to (0) trunk names
are printed instead.
17
Print Account Code or Caller Name of Incoming
Call
Determine if SMDR should print Account Code or
Caller Name of Incoming Call.
18
Print Mode for Caller Name of Incoming Call
Determine how SMDR should print Caller Name of
Incoming Call.
Item
Program 35 : SMDR Account Code Setup
UNIVERGE SV8100
Input Data
0 = Not Displayed
1 = Displayed
0 = Not Displayed
1 = Displayed
0 = Name
1 = Number
0 = Not Displayed
1 = Displayed
0 = Not Output
1 = Output
0 = Not Displayed
1 = Displayed
0 = Not Displayed
1 = Displayed
0 = Not Displayed
1 = Displayed
0 = CLI (CLIP)
1 = DID Calling
Number
0 = Trunk Port Name
1 = Received Dialed
Number
2 = Both (OT)
0 = ACC
1 = CNAME
0 = Normal
1 = Line Feed
Default
1
1
0 (OT)
1 (AU)
0
1
0
0
0
0
0
0
0