NEC Univerge SV8100 Programming Manual page 499

UNIVERGE SV8100
Item
No.
04
Route Table Setup of Target Dial
The option sets how the system uses
the route data (gathered in Item 3) to
route incoming ANI/DNIS calls.
If option 2 is selected, and the call is
to be routed using the DID table (1),
up to eight digits can be matched.
The number of expected digits set in
Program 22-09-01 must match the
ANI digits defined in Program 22-11-
01. For example, if an ANI/DNIS
number received was
20355512343001 and Program
22-09-01=4, the entry in 22-11-01
must be 1234 with the defined target
extension.
If the call is to be routed using the
ABB table (0), up to 24 digits can be
matched. Define the range of the
ABB table to be used in Program 34-
09-06. The data is compared to the
entries in Program 13-04-01 and then
routed according to Program 13-04-
03.
05
ANI/DNIS Display as Target Dial
Name
Use this option to set whether or not
ANI data should appear on telephone
displays as part of Caller ID display.
06
Routing SPD Table Setup
Use this option to define which part of
the ABB Table set up in Program 13-
04 the system uses for ANI/DNIS
Caller ID look-ups and ANI/DNIS
routing.
This is required if Items 4 and 5
above are 1 (Caller ID on). When you
specify a starting and end address,
the system uses the part of the table
for look-ups.
When you specify a starting address
and length, the system uses that part
of the table for routing. If the incoming
ANI/DNIS number data matches the
Number entry in the table, the system
routes according to the associated
Name data. That data can be an
extension, Department Group pilot
number, the voice mail master
number or a trunk ring group.
Programming Manual
Name
0
1
0
1
Start = 0, 100~1900
End
Default
Input Data
COS 1
= SPD Table
(Program 13-03)
= DID Table
(Program 22-11)
= Display Off
= Display On
Start =
= 0, 99~1999
End =
Issue 10.1
Default
Related
Program
COS
2~15
0 0 13-04
22-11-03
34-09-05
1 0 13-04
20-09-02
22-11-03
23-09-04
Start = 0 13-04
1000 End = 0
1199
2 - 463