NEC Univerge SV8100 Programming Manual page 840

Issue 10.1
Input Data
Item
No.
21
22
24
26
2 - 804
Item
Signal Limiter
Set the Signal Limiter Mode.
Not used by IPLB.
Echo Canceller NLP Mode
Non-linear processing mode.
Enable this option to decrease the low
level echo. When NLP is enabled, the
voice with low level is replaced with NLP
noise. As a result, a low echo of the level
is usually removed compared with the
conversation level.
Not used by IPLB. Echo canceller setup is
84-31 for IPLB.
Echo Canceller NLP Noise Setting
Becomes invalid item if 84-12-22 is set to
Disabled.
Set the noise level adjusting method
added with NLP.
When "0" is set, the level is self-adjusted -
when "1" is set, Program 84-01-27 is
used.
Not used by IPLB. Echo canceller setup is
84-31 for IPLB.
TX (Transmit) Gain
Define the setting to amplify and to
attenuate the size of the transmission
voice. The gain given when the voice
packet is sent from the VOIPDB is set.
Not used by IPLB. Echo canceller setup is
84-31 for IPLB.
UNIVERGE SV8100
Input Data
1 = Mode0
2 = Mode1
3 = Mode2
4 = Mode3
5 = Mode4
6 = Mode5
1. There is no limitation.
2. The limitation is the
maximum.
3. Limitation size
4. It is limiting it.
5. Limitation smallness
6. The limitation is minimum.
0 = 2 wire & 4 wire
1 = 2 wire only
0 = adaptive
1 = fixed
0-40 (-20 ~ +20)
0 = -20 dbm
1 = -19 dbm
:
20 = 0 dbm
:
39 = 19 dbm
40 = 20 dbm
Program 84 : Hardware Setup for VoIP
Default
6
1
0
20 (0dbm)