NEC Univerge SV8100 Programming Manual page 354

Issue 10.1
Item
No.
12
PBX Call
Restriction
13
Restriction of Tie
Line Calls
14
Trunk Transfer
Restriction on
Incomplete Dial
15
Common Hold
Restriction on
Incomplete Dial
2 - 318
Item Input Data
0 = Disable
(No)
1 = Enable
(Yes)
0 = Disable
(No)
1 = Enable
(Yes)
0 = Not allow
1 = Allow
0 = Not allow
1 = Allow
Default Description
1~6, 8~15 =
Use this option to set how
0
the system Toll Restricts
calls over PBX trunks. If you
7 = 1
enable PBX Toll Restriction,
the system begins Toll
Restriction after the PBX
access code. The user
cannot dial a PBX extension.
If you disable PBX Toll
Restriction, the system only
restricts calls that contain
the PBX access code. The
system does not restrict
calls to PBX extensions.
Refer to the PBX
compatibility feature. Make
sure Program 21-05-04
(Maximum Number of Digits
Table Assignment) allows for
PBX Toll Call Dialing
(normally 12 digits).
0
It chooses whether the toll
restriction of the dial set up
by 34-08 is enabled or
disabled.
0 If this program is set to 1,
you can transfer the
outgoing trunk which you
dialed incompletely.
0 If this program is set to 1,
you can hold the outgoing
trunk which you dialed in
restriction check.
Program 21 : Outgoing Call Setup
UNIVERGE SV8100
Related
PRG
34-08