Program 92 : Copy Program; Copy Program - NEC Univerge SV8100 Programming Manual

Level:
IN
Description
(This program is available only via telephone programming and not through
PC Programming).
Use Program 92-01 : Copy Program to copy the data for one program to
another multiline terminal, port, group, or other number. Refer to the following
charts to see which programs can be copied.
Input Data
Item
No.
01
Programming Manual

Program 92 : Copy Program

Program Number
Item
Source Number
Enter the extension, trunk, group or other
number from which the data is to be
copied.
Destination Number (From)
Enter the first extension, trunk, group or
other number to which the information is
to be copied.
Destination Number (To)
Enter the last extension, trunk, group or
other number to which the information is
to be copied. If the information is being
copied only to one extension, trunk, group
or other number, enter the information
entered in the Destination Number (From)
entry.

92-01 : Copy Program

XX-XX
Input Data
For Trunk Base:

Trunk Port Number 1~200
For Trunk Group Base:

Trunk Group Number 1~100
For Extension Base:

Extension Number (up to eight digits)
For Department Group Base:

Department Group Number 1~64
For DSS:

DSS Console Number 1~32
Program
92
2 - 929