Dtmf And Dial Tone Circuit Setup - NEC Univerge SV8100 Programming Manual

UNIVERGE SV8100
Program 10 : System Configuration Setup
Level:
IN
Description
Use Program 10-09: DTMF and Dial Tone Circuit Setup to allocate the circuits on
the CD-CP00 for either DTMF receiving or dial tone detection. The CD-CP00 has 32
circuits initially, and an additional 64 circuits are added when a PZ-BS10 is installed.
These are used as follows:


Input Data
Item
Programming Manual

10-09 : DTMF and Dial Tone Circuit Setup

Extension DTMF receiver for single line telephone
Trunk DTMF receiver for analog trunks, dial tone & busy tone detection
for analog trunks
Circuit/Resource Number
Input Data
No.
01 0 = Common Use
1 = Extension Only
2 = Trunk Only
Conditions
CD-CP00 has 32 channel DSP resources (receivers) only for basic chassis. PZ-

BS10 have 64 DSP resources (receivers) only for expand chassis.
In case of 0 (= Common) is selected, and if 14-02-10 (Caller ID receive ability) is

set to "Yes", DSP resources are always allocated to analog trunk only, not for
analog extension. If 14-02-10 is set to "No", the DSP resources can be used for
both analog trunk and analog extension commonly.
Default Setting
Circuit/Resource 01~08 = 1 (Extensions)
Circuit/Resource 09~32 = 2 (Trunks)
(Circuit/Resource 33~96 are not used.)
Circuit/Resource 97~160 = 0 (Common)
When PZ-BS10 is installed, 97~160 are available.
Issue 10.1
01~160
2 - 23