NEC Univerge SV8100 Programming Manual page 623

UNIVERGE SV8100
Input Data
Item
No.
02
Programming Manual
Item
Override Mailbox Category
(Override MB Ctg)
Use this option to specify the category of the
mailbox where Automated Attendant calls should
route when you enable Answer Schedule Override.
VM8000 InMail mailbox categories are Subscriber
Mailbox, Master Mailbox, and Routing Mailbox.
VM8000 InMail handles the routing according to the
type of mailbox (Subscriber, Call Routing, or
Announcement) within the specified category:
If the Override Mailbox is a Subscriber Mailbox,

the outside caller hears the mailbox greeting (if
recorded) and can leave a message.
If the Override Mailbox is an Announcement

Mailbox, the outside caller shears the recorded
announcement. Depending on how the
Announcement Mailbox is programmed,
VM8000 InMail then hangs up, reroutes the
call, or provides additional dialing options.
If the Override Mailbox is a Call Routing

Mailbox, the outside caller hears the instruction
menu and can dial any option allowed by the
associated Dial Action Table.
 If any of the Input Data values are entered, the
terminal displays the Override Mailbox
Number selection (below).
Override Mailbox Number
(Override MB Num)
Use this option to specify the mailbox where
Automated Attendant calls should route when you
enable Answer Schedule Override. The mailbox
number you select in this option should match the
mailbox category specified in 47-11-02: Override
Mailbox Category above.
Input Data
0 (Undefined)
1 (Subscriber
Mailbox – STA)
2 (Group Mailbox)
3 (Routing Mailbox)
No Setting
Digits
(three maximum,
using 0~9)
Issue 10.1
Default
0
2 - 587