Installing Power Supplies In A Netiron Xmr 16000 Router - Brocade Communications Systems MLX Series Hardware Installation Manual

3
Installing a NetIron XMR 16000 router
1 Interface module
5. Tighten the screws at each end of the module faceplate by pushing them in and turning them

Installing power supplies in a NetIron XMR 16000 router

This section describes how to install power supplies in the NetIron XMR 16000 router.
Follow these steps to install a power supply in a NetIron XMR 16000 router.
1. Remove the power supply slot blank.
2. Remove the power supply from the packaging.
3. Insert the power supply into the slot, using the guides on each side of the slot. Refer to
FIGURE 112
166
clockwise. Complete the tightening process using the flat-blade screwdriver.
Table 112.
Installing a power supply in a NetIron XMR 16000 router
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01