Brocade Communications Systems MLX Series Hardware Installation Manual page 195

•
FIGURE 120
:
CAUTION
Be sure not to exceed the minimum recommended bend radius for the cables: 2 in. for MRJ-21
cables, and 1.5 in. for Category 5 (RJ45) and fiber-optic cables.
Cable routing for the upper-left quadrant
Route cabling from slots in numerical order starting with the cables for slot #1.
1. Route cables for slots #1 and #2 directly to the left through the side comb. Refer to
FIGURE 121
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
Always route the cables for the outer-most modules out the sides of the unit. Route the cables
for the innermost modules through the top or through the bottom cable management hardware
on the unit.
NetIron XMR 32000 cable routing scheme
Routing upper-left quadrant cables
Installing a NetIron XMR 32000 router
3
Figure 121.
179