Brocade Communications Systems MLX Series Hardware Installation Manual page 183

1
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted. Never insert the power supply upside down.
4. Push the power supply faceplate toward the back of the router until the power supply
For information about connecting power to the router, refer to
information about powering on the system, refer to
Connecting AC power
AC power is supplied through a power cord connected to the power supply installed in the NetIron
XMR 16000 router.
Follow these steps to connect the AC power source.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
2
Power supply 2 Release latch
connector engages the backplane connector and the latch pin clicks into place.
Installing a NetIron XMR 16000 router
1
"Activating the power source"
"Connecting AC power"below. For
on page 194.
3
167