Brocade Communications Systems MLX Series Hardware Installation Manual page 192

3
Installing a NetIron XMR 32000 router
For information about how to disable and re-enable power to interface modules, refer to
and re-enabling power to interface modules"
Before installing a module in the NetIron XMR 32000 router, have the following items available:
•
•
DANGER
For safety reasons, the ESD wrist strap should contain a 1 megohm series resistor.
CAUTION
If you are hot-swapping a module, allow a minimum of two seconds after a module (or power
supply or fan tray) has been removed before inserting a module in the same slot.
Follow these steps to install a module in the NetIron XMR 32000 router. The installation steps are
identical for management modules, interface modules, and switch fabric modules.
1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on
2. Remove the module from the packaging.
3. Remove the two shipping panels by unscrewing the six captive screws holding each panel.
4. With the ejectors rotated away from the module faceplate, insert the module into the slot (refer
5. Rotate the ejectors flush with the module faceplate to seat the module in the backplane.
FIGURE 118
176
A large flat-blade screwdriver.
An ESD wrist strap with a plug for connection to the ESD connector on the router chassis.
the router chassis.
to Table 25) and slide the module along the card guide until the ejectors rotate towards the
module faceplate.
NOTE
When inserting the module into the router, make sure that the faceplate doesn't overlap with
the faceplate of an adjacent interface module.
Modules have a snug fit for maximum EMI protection.
Installing a module in the NetIron XMR 32000 router
on page 223.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
"Disabling
53-1003821-01