Installing Netiron Xmr 4000 Router Power Supplies - Brocade Communications Systems MLX Series Hardware Installation Manual

3
Installing a NetIron XMR 4000 router
3. With the ejectors in the outward position, insert the module into the appropriate slot (refer to
FIGURE 96
4. Rotate the ejectors flush with the module faceplate to fully seat the module in the backplane.
5. Tighten the screws at each end of the module faceplate by pushing them in and turning them

Installing NetIron XMR 4000 router power supplies

You will need a small Phillips or flat-blade screwdriver to install power supplies.
Follow these steps to install a power supply.
1. Remove the power supply slot blank.
2. Remove the power supply from the packaging.
3. Insert the power supply into the empty power supply slot, using the card guides on each side of
146
Table 25) and slide the card along the card guide until the ejectors on either side of the
module rotate towards the module faceplate.
Installing a module in the NetIron XMR router
NOTE
When inserting the module into the router, make sure that the faceplate doesn't overlap with
the faceplate of an adjacent module.
Modules have a snug fit for maximum EMI protection.
clockwise. Complete the tightening process using the flat-blade screwdriver.
the slot. Slide the card along the card guides until the ejectors on either side of the power
supply rotate towards the faceplate.
NOTE
Empty power supply slots must be covered with slot blanks.
Do not overtighten screws when installing power supplies.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01