Interfaces Bridge <Brx> Ipv6 Router-Advert - Brocade Communications Systems 5600 Configuration Manual

interfaces bridge <brx> ipv6 router-advert
Specifies the router advertisements to be sent from the bridge interface.
Syntax
set interfaces bridge
mtu I managed-flag state I max-interval interval I min-interval interval I other-config-flag state I prefix ipv6net
mtu
[autonomous-flag
retrans-timer
delete interfaces bridge
max-interval I min-interval I other-config-flag I prefix
lifetime] I reachable-time I retrans-timer I send-advert]
show interfaces bridge
Command Default
Router advertisements are not sent on an interface.
Parameters
brx
Bridge group ID.
limit
cur-hop-limit
Specifies the Hop Count field of the IP header for outgoing (unicast) IP packets. This value is placed in the Hop Count
field of the IP header for outgoing (unicast) IP packets. The range is 0 to 255. The default is 64. A value of 0 means
unspecified by the router.
lifetime
default-lifetime
Specifies the lifetime, in seconds, associated with the default router. Supported values are 0, which indicates that the
router is not a default router, and the range from the value is configured for the max-interval option to 9000 (18.2
hours). If not configured, the value for this timer is three times max-interval.
default-preference
The preference associated with the default router. Supported values are as follows: low: The default router is low
preference. medium: The default router is medium preference. high: The default router is high preference.The default
is medium.
mtu
link-mtu
The MTU value to be advertised for the link. The range of values is 0, or 1280 to the maximum MTU for the type of
link, as defined in RFC 2464. The default is 0, which means the MTU is not specified in the router advertisement
message. That is because it is expected that the MTU will be configured directly on the interface itself and not for
routing advertisements. You can configure this option in cases where the link MTU is not well known.
If the value set here does not match the MTU configured on the interface, the system issues a warning but does not
fail.
managed-flag state
Whether to use the administered protocol for address autoconfiguration. Supported values are as follows: true: Hosts
use the administered (stateful) protocol for address autoconfiguration in addition to any addresses autoconfigured
34
brx ipv6 router-advert [cur-hop-limit limit I default-lifetime lifetime I default-preference preference I link-
state | on-link-flag state | preferred-lifetime lifetime | valid-lifetime lifetime ] I reachable-time time I
time I send-advert state ]
brx ipv6 router-advert [cur-hop-limit I default-lifetime I default-preference I link-mtu I managed-flag I
brx ipv6 router-advert
preference
ipv6net [autonomous-flag | on-link-flag | preferred-lifetime | valid-
Bridge Group Commands
Brocade 5600 vRouter Bridging Configuration Guide
53-1004250-01