Brocade Communications Systems MLX Series Hardware Installation Manual page 306

7
Replacing fan assemblies
3. If louvers are present inside the fan assembly faceplate, detach them by removing the 11 roll
NOTE
Legacy Brocade MLX-32 fan assemblies may have louvers. Louvers are not present in newer
Brocade MLX-32 fan assemblies.
FIGURE 169
4. Remove the fan assembly handle by detaching the two screws from the inside of the fan
FIGURE 170
290
pins that secure the louvers to the inside of the fan assembly faceplate.
Removing the louver on a legacy chassis.
The louvers will fall out of the fan assembly faceplate as you pull out the roll pins. Refer to
Figure 169.
assembly faceplate using a Phillips screwdriver. Refer to
Handle removal
Figure
Brocade MLX Series and NetIron XMR Hardware Installation Guide
170.
53-1003821-01