Brocade Communications Systems MLX Series Hardware Installation Manual page 46

1
Router modules
BR-MLX-40Gx4-M 4-port 40GbE module
Figure 23
FIGURE 23
FIGURE 24
The front panel includes the following features:
•
•
•
•
Table 14
TABLE 14
LED
Link or
Active
Power
The Brocade MLXe 4-port 40 GbE (M) module includes Layer 2, IPv4/IPv6, MPLS and OpenFlow
features, supports 512K IPv4 routes in the Forwarding Information Base (FIB), and requires high
speed switch fabric modules and QSFP+ optics.
30
The output displays firmware Revision A (Rev A) for NIBI-16-FAN-EXH-A modules. Rev A
indicates that the router contains the required rear fan modules to support the
NI-MLX-1Gx48-T-A modules. The RPM value thresholds (LOW/MED/MED-HI/HI) are also
displayed for rear fan modules.
NOTE
If the router does not contain NIBI-16-FAN-EXH-A modules, the show chassis command will not
display Rev A for rear fan modules.
and Figure 24 shows the front panel for the BR-MLX-40Gx4-M interface module.
BR-MLX-40Gx4-M module front panel
BR-MLX-40Gx4-M module front panel side view
Name of the module.
Number of ports and the type of ports.
LED indicator for a port.
LED indicator for module power.
describes the BR-MLX-40Gx4-M module LEDs.
BR-MLX-40Gx4-M module LEDs
Position
Above the ports
Left side of front panel
State Meaning
On (solid) A link is established.
Blinking The port is transmitting and/or receiving.
Off A link is not established.
On Module is powered on.
Off Module is powered off.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01