Accessing Modules For Service - Brocade Communications Systems MLX Series Hardware Installation Manual

1
2
2. Route cables from slots #30 and #29 down through comb A. Refer to
3. Route cables from slots #28 and #27 down through comb B.
4. Route cables from slots #26 and #25 down through comb C.

Accessing modules for service

With the cables bundled correctly, it is easier to access the modules for service. Gently move the
cable bundles to the side to access a module. Use the appropriate Phillips or flat-blade screwdriver
with an extended shaft to disconnect the cables from the module and remove the module. There is
no need to undo the cable cinches or cable ties. Refer to
NOTE
This procedure is easier with two people. One person can hold the cable bundles aside while the
other person loosens the connectors and removes the module.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
Lower right quadrant
Comb A (slots #29 and #30 cables)
Installing a NetIron XMR 32000 router
1
2
3
4
3 Comb B (slots #27 and #28 cables)
4 Comb C (slots #25 and #26 cables)
Figure .
3
Figure 128.
187