Brocade Communications Systems MLX Series Hardware Installation Manual page 257

TABLE 39
show chassis command output
(sensors)
LP Sensor 2 reading (TM 0)
LP Sensor 3
LP Sensor 4
NI-MLX-10Gx8-M LP Modules
LP2 Sensor 1 reading
LP2 Sensor 2 reading
LP2 Sensor 3 reading
LP2 Sensor 4 reading
LP2 Sensor 5 reading
LP2 Sensor 6 reading
LP2 Sensor 7 reading
BR-MLX-100Gx2-X LP Modules
LP2 Sensor 1 reading
LP2 Sensor 2 reading
LP2 Sensor 3 reading
LP2 Sensor 4 reading
LP2 Sensor 5 reading
LP2 Sensor 6 reading
LP2 Sensor 7 reading
LP2 Sensor 8 reading
LP2 Sensor 9 reading
LP2 Sensor 10 reading
LP2 Sensor 11 reading
LP2 Sensor 12 reading
a.
Sensor5. In that case, Sensor4 and Sensor 5 refer to the LP and LP XPP sensors on the second traffic manager, TM 1.
b.
Sensor5. In that case, Sensor4 and Sensor 5 refer to the LP and LP XPP sensors on the second traffic manager, TM 1.
Changing the temperature polling interval
By default, the router reads the temperature sensor on each module every 60 seconds. To change
the polling interval, enter the temp-poll-period command at the global CONFIG level of the CLI.
Brocade(config)# temp-poll-period 120
Syntax: temp-poll-period <seconds>
For the seconds parameter, you can specify a value from 30 – 120.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
Associations between show chassis, show fan threshold, and fan-threshold commands (Continued)
a
reading (TM 1)
b
reading (TM 1)
The four sensors may be displayed in the
The four sensors may be displayed in the
show fan-threshold command output
(thermal block)
THERMAL_SENSOR_TEST_RULE_LP_XPP
THERMAL_SENSOR_TEST_RULE_LP
THERMAL_SENSOR_TEST_RULE_LP_XPP
THERMAL_SENSOR_TEST_RULE_LP_2
THERMAL_SENSOR_TEST_RULE_LP_XPP2
UNUSED
THERMAL_SENSOR_TEST_RULE_LP_2
THERMAL_SENSOR_TEST_RULE_LP_XPP2
UNUSED
UNUSED
THERMAL_SENSOR_TEST_RULE_LP_2
THERMAL_SENSOR_TEST_RULE_LP_XPP2
UNUSED
THERMAL_SENSOR_TEST_RULE_LP_2
THERMAL_SENSOR_TEST_RULE_LP_XPP2
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
show chassis
command output as Sensor1, Sensor2, Sensor4, and
show chassis
command output as Sensor1, Sensor2, Sensor4, and
Managing the cooling system
fan-threshold command
configuration
N/A (Must not be changed)
fan-threshold lp
N/A (Must not be changed)
fan-threshold lp2
N/A (Must not be changed)
UNUSED
fan-threshold lp2
N/A (Must not be changed)
UNUSED
UNUSED
fan-threshold lp2
N/A (Must not be changed)
UNUSED
fan-threshold lp2
N/A (Must not be changed)
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
UNUSED
6
241