Brocade Communications Systems MLX Series Hardware Installation Manual page 114

2
Installing a Brocade MLX-32 router
5. Visually inspect the alignment of the router. If the router is installed properly, the mounting
FIGURE 67
1
2
3
6. Remove the strap securing the router to the mechanical lift.
7.
8. For a mid-mount, remove the factory-installed mounting brackets from the front edges of the
9. If you are installing the router in a standard rack, install a mounting screw and a cage nut into
98
screws on both sides rack should be aligned with the mounting screws on the opposite side
and the router should be level.
Secure the router to the rack
Router installed in open frame rack
Rack mounting poles
Router mounting brackets
With two people in front and two people in back, slide the router into the rack.
device. Re-attach the mounting brackets to the center sides of the device using the pre-drilled
holes in the device. For a front-mount, use the brackets as they were installed at the factory.
each of the holes on the rack posts aligned with the threaded holes in the spacer bars.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01