Brocade Communications Systems MLX Series Hardware Installation Manual page 308

7
Replacing fan assemblies
7.
NOTE
Replacing the tape is not required.
Reinstalling the modified fan assembly in the chassis
To reinstall the modified fan assembly, complete the following steps:
1. Insert the modified fan assembly into the fan slot and push the assembly in until the fan
2. Secure the fan assembly to the router by replacing and tightening the four screws.
3. Check the fan status LED in the lower left corner of the faceplate. It will glow red momentarily
4. To verify that the fan is operating correctly, access the CLI and enter the show chassis
292
Re-attach the fan assembly faceplate to the fan assembly by securing three screws on each
side.
assembly faceplate is flush with the chassis. Pushing the fan assembly in seats the fan
connector in the router connector.
when power is applied, and then it will change to green when the fan comes up to speed.
command.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01