Brocade Communications Systems MLX Series Hardware Installation Manual page 158

3
Installing a NetIron XMR 4000 router
To perform this task, you need a #2 Phillips-head screwdriver.
FIGURE 93
1
2
Follow these steps to mount a NetIron XMR 4000 router in a rack.
1. Determine the position of each router in the rack. For example, place routers with the fewest
2. Position two of the four mounting screws for each router according to the spacings of the
FIGURE 94
1
142
Shipping screw locations
Front
Rear
modules near the top of the rack, routers with more modules near the middle of the rack, and
fully populated routers near the bottom of the rack.
keyhole slots on the mounting brackets, as shown in
screws in the rack post, leave approximately 1/4 inch clearance between the back of the screw
head and the rack post.
Positioning the mounting screws in rack posts
Unequal flange equipment rack
3 Shipping screws
Figure 94. When tightening the mounting
2 Network equipment rack
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01