Table of Contents
Advertisement
Installing a Brocade MLXe Series-4 router
CAUTION
If you do not install a module or a power supply in a slot, you must keep the slot filler panel in place. If you run the chassis
with an uncovered slot, the system will overheat.
NOTE
If you are hot-swapping a module, allow a minimum of two seconds after a module (or power supply or fan tray) has been
removed before inserting a module in the same slot.
Although the slot blanks differ in size, the procedure for removing them is identical. You will need a flat-blade screwdriver to remove slot
blanks.
Follow these steps to remove a slot blank.
1.
Loosen the screws on either end of the slot blank by hand or with a flat-blade screwdriver.
2.
Pull the slot blank out of the router, and store it in a safe place for future use.
Follow these steps to install a module.
Installing power supplies in a Brocade MLXe Series-4 router
Follow these steps to install a power supply.
1.
Remove the power supply slot blank and store it for future use.
2.
Remove the power supply from the packaging.
98
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04
Advertisement
Table of Contents
