Power Supplies - Brocade Communications Systems NetIron CES 2000 Series Hardware Manual

Type : Copper
Vendor:
Part# :
Port 1/24:
Type : Copper
Vendor:
Part# :
Port 2/1:
Type : 10GBASE-SR/SW (XFP)
Vendor: FOUNDRY NETWORKS, Version:
Part# : FTLX8511D3-F1
Port 2/2:
Type : 10GBASE-SR/SW (XFP)
Vendor: FOUNDRY NETWORKS, Version:
Part# : TRF2000EN-LF251 , Serial#:
All show media done
Syntax: show media

Power Supplies

Each NetIron CES 2000 Series switch comes with one alternating-current (AC) power supply. All models have two
power supply slots, enabling you to install a second power supply for redundancy.
CAUTION: Changes or modifications made to this device that are not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
The power supplies can be swapped in or out of the device while the device is running. You can remove and insert
a power supply without opening the chassis. The remaining supply provides enough power for the entire system.
The following sections provide further details about the power supplies for the NetIron CES 2000 Series of
switches:
• Power status LEDs are listed in "Observing the Power Status LEDs" on page 3-14.
• Hardware specifications for the power supplies are listed in "Hardware Specifications" on page C-1.
• "About Redundant Power Supplies and Power Supply Failure" on page 2-12
March 2009
, Version:
Unknown, Serial#:
, Version:
Unknown, Serial#:
, Serial#:
© 2009 Brocade Communications Systems, Inc.
Unknown
Unknown
Unknown
Unknown
00
KCP02X8
02
T07J23170
Product Overview
2 - 11