Syslog Messages - Brocade Communications Systems MLX Series Hardware Installation Manual

6
Monitoring Link Status
SFM#/FE# | FE link#
----------+-----------+---------+-----------+---------
1 / 1
1 / 1
1 / 1
Syntax: show sfm-links <sfm-number> | all [ errors ]
The sfm-number variable specifies an SFM that you want to display link information for.
The all option displays link information for all SFMs in the chassis.
The errors option only displays information for SFM links that are in the DOWN state.
The output of this command can also be filtered using an output modifier. To use an output
modifier, type a vertical bar ( | ) followed by a space and one of the following parameters:
•
•
•
A warning statement is sent if the number of operational links falls below the minimum threshold.
This warning is displayed to warn users that the line rate traffic will not be maintained.
Table 41
TABLE 41
This field...
SFM#
FE#
FE link#
LP#
TM#
TM link#
link state

Syslog messages

The following syslog messages are related to link monitoring:
•
•
252
| LP#/TM# | TM link#
| 13 | 2 / 1
| 17 | 2 / 2
| 14 | 2 / 1
begin - begin output with the first matching line
exclude - exclude matching lines from the output
include - include only matching lines in the output
describes the information the show sfm-links command displays.
CLI display of SFM link information
Displays...
The switch fabric module number.
The FE number.
The number of the interconnect between the SFM and the FE.
The slot number where the Interface module (LP) is installed.
The number of the traffic manager used in the link.
The link number on the traffic manager.
The link state is either:
UP - In an operating condition
DOWN - In a non-operational condition
System: Interface Ethernet 3/1, state down -fabric connectivity down
System: Interface Ethernet 3/1, state up –fabric connectivity up
| link state
| 13 | UP
| 01 | DOWN
| 01 | UP
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01