Brocade Communications Systems MLX Series Hardware Installation Manual page 145

3. New module should come up in interactive state, and can be code synced at this time if
4. Enter configuration mode.
5. Execute the following command:
6. Answer
7.
8. Apply the appropriate configuration to the interfaces of the new module.
9. Execute write memory to save the new configuration.
The following example demonstrates the forced card deletion feature:
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
needed.
Brocade(config)#no module <slot> <module-type>
Example:
Brocade(config)#no module 2 ni-mlx-8-port-10g-d
NOTE
This is best pulled directly from the running configuration.
to the prompt by pressing
yes
Wait for the new module to come up.
Brocade#show module
Module
MAC
M1 (left):BR-MLX-MR2-M Management Module
M2 (right):NI-MLX-MR Management Module
F1:
F2: NI-X-HSF Switch Fabric Module
F3: NI-X-HSF Switch Fabric Module
S1: BR-MLX-40Gx4-M 4-port 40GbE Module
0024.3887.3f00
S2: NI-MLX-10Gx8-D 8-port 10GbE (D) Module
0024.3887.3f30
S3: NI-MLX-10Gx8-D 8-port 10GbE (D) Module
0024.3887.3f60
S4: NI-MLX-10Gx8-M 8-port 10GbE (M) Module
0024.3887.3f90
S5: NI-MLX-10Gx8-M 8-port 10GbE (M) Module
0024.3887.3fc0
S6: NI-MLX-1Gx20-GC 20-port 10/100/1000
Copper Module
0024.3887.3ff0
S7: NI-MLX-10Gx8-M 8-port 10GbE (M) Module
0024.3887.4020
S8: BR-MLX-40Gx4-M 4-port 40GbE Module
0024.3887.4050
Brocade#
Brocade#show running-config | include module
module 1 br-mlx-4-port-40g-m
module 2 ni-mlx-8-port-10g-d
module 3 ni-mlx-8-port-10g-d
module 4 ni-mlx-8-port-10g-m
module 5 ni-mlx-8-port-10g-m
module 6 ni-mlx-20-port-1g-copper
module 7 ni-mlx-8-port-10g-m
module 8 br-mlx-4-port-40g-m
snmp-server max-ifindex-per-module 64
Verifying proper operation
.
y
Status
Active
Standby(Ready State)
Active
Active
CARD_STATE_UP
CARD_STATE_UP
CARD_STATE_UP
CARD_STATE_UP
CARD_STATE_UP
CARD_STATE_UP
CARD_STATE_UP
CARD_STATE_UP
2
Ports Starting
4
8
8
8
8
20
8
4
129