Brocade Communications Systems MLX Series Hardware Installation Manual page 39

FIGURE 17
NI-MLX-10Gx8-M and NI-MLX-10Gx8-D modules support the SFP+ optics; they do not support SFP
optics. For a list of supported SFP+ optics, refer to the latest version of the Brocade Optics Family
Data Sheet, available online in the following location:
http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/optics-famil
y-ds.pdf
NI-MLX-10Gx8-M and NI-MLX-10Gx8-D interface module LEDs
The NI-MLX-10Gx8-M and NI-MLX-10Gx8-D interface module LEDs indicate module and port status,
as described in
TABLE 9
LED
Power
Link/Activity
Installation considerations
When you install NI-MLX-10Gx8-M or NI-MLX-10Gx8-D modules, you must upgrade the software on
all interface modules and management modules to the appropriate software release. Refer to the
Hardware Installation Notes that shipped with the interface module.
NOTE
NI-MLX-10Gx8-D modules do not support Multiprotocol Label Switching (MPLS).
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
Port RX and TX, and LED designations for NI-MLX-10Gx8-M and NI-MLX-10Gx8-D modules
Table 9.
NI-MLX-10Gx8-M and NI-MLX-10Gx8-D interface module LEDs
Location
Lower left corner of module
Underneath the ports. Top port LED
on left, bottom port LED on right.
Router modules
State Meaning
Green Module is receiving power
Off Module is not receiving power
Green Port enabled and link is up.
blinking
Off Port is disabled.
1
23