Brocade Communications Systems MLX Series Hardware Installation Manual page 34

1
Router modules
The front panel includes the following features:
•
•
Table 5
TABLE 5
Position
Arrow-shaped LEDs in center
horizontal strip between ports.
Left LEDs support upper ports.
Right LEDs support lower ports.
Power supply requirements for BR-MLX-10Gx24-DM modules
For power supply requirements for BR-MLX-10Gx24-DM interface modules, refer to
"Hardware
8x10GE-X interface modules
The 8x10GE-X interface modules provide 8 ports of 10 Gigabit Ethernet with support for up to 1M
IPv4 routes in hardware.
NOTE
Gen-2 8x10GE-X modules require high speed switch fabric modules to operate. You can replace
switch fabric modules with high-speed switch fabric modules while the system is powered on and
running. For more information about high-speed switch fabric modules, refer to
fabric modules"
For Brocade XMR 16-slot routers, 8x10GE-X modules require the installation of high-speed fans in
addition to high-speed switch fabric modules. For information about the high-speed fans, see
"NIBI-16-FAN-EXH-A high-speed fan assemblies"
Figure 13
FIGURE 13
18
Arrow-shaped LEDs in center horizontal strip for all ports. LEDs to the left support the top
ports, LEDs to the right (pointing down) support the bottom ports.
Twenty four 10G Ethernet ports
describes the LEDs for the BR-MLX-10Gx24-DM interface modules.
BR-MLX-10Gx24-DM module LEDs
Specifications".
on page 33.
shows the faceplate of the 8x10GE-X module.
8x10GE-X module faceplate
State Meaning
Solid green A link has been established.
Green blinking The port is transmitting and receiving packets.
Off No link exists, and the port is not transmitting or receiving
packets.
on page 40.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
Chapter 8,
"High-speed switch
53-1003821-01