Brocade Communications Systems MLX Series Hardware Installation Manual page 35

8x10GE-X modules support SFP+ optics only; they do not support SFP or XFP optics. For a list of
supported SFP+ optics, refer to the latest version of the Brocade Optics Family Data Sheet,
available online in the following location:
http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/optics-famil
y-ds.pdf
8x10GE-X interface module LEDs
The 8x10GE-X interface module LEDs indicate module and port status, as described in
TABLE 6
LED
Power
Link/Act
Power supply requirements for 8x10GE-X modules
For power supply requirements for the 8x10GE-X modules, refer to
Specifications".
Gen-1 10Gx2 and 10Gx4 Ethernet interface modules
Gen-1 2-port and 4-port 10 Gbps Ethernet interface modules are available in the following formats:
•
•
•
•
NOTE
When you install Gen-1 2-port or 4-port 10 Gbps Ethernet interface modules, you must upgrade the
software on all interface modules and management modules to the appropriate software release.
For more information on the appropriate software release refer to the Hardware Installation Notes
that shipped with the interface module.
Figure 14
FIGURE 14
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
8x10GE-X module LEDs
Location
Lower left corner of module
Below the ports. Top port
LED on left, bottom port LED
on right.
NI-MLX-10Gx2 - 2-port interface module for MLX devices
NI-XMR-10Gx2 - 2-port interface module for XMR devices
NI-MLX-10Gx4 - 4-port interface module for MLX devices
NI-XMR-10Gx4 - 4-port interface module for XMR devices
shows Gen-1 2-port and 4-port 10 Gbps Ethernet interface module front panels.
Gen-1 2-port and 4-port 10 Gbps Ethernet module front panels
State Meaning
Green Module is receiving power
Off Module is not receiving power
Green Port enabled and link is passing traffic. LED is solid
blinking green when link is idle.
Off Port is disabled.
Chapter 8, "Hardware
1
Router modules
Table 6.
19