Brocade Communications Systems MLX Series Hardware Installation Manual page 41

Figure 18
FIGURE 18
The front panel includes the following features:
•
•
Table 10
TABLE 10
Position
LEDs located at top right and
left edge of top row ports. Left
LED for top port, right LED for
bottom port)
Power supply requirements for BR-MLX-1GCx24-X interface modules
For power supply requirements for BR-MLX-1GCx24-X interface modules, refer to
"Hardware
24-port 1 Gbps fiber interface module
The 24-port 1 Gbps fiber interface module is available in the following formats:
•
•
The 24-port 1 Gbps fiber interface modules has 32 Mb of flash memory and provide 24 physical
ports, through which you can connect your router to other network routers. BR-MLX-1GFx24-X-ML
supports up to 512K IPv4 routes in hardware. BR-MLX-1GFx24-X supports up to 1M IPv4 routes in
hardware. The ML version can be upgraded to a X version through a software license. Please
contact Brocade to purchase the license upgrade.
NOTE
24-port 1 Gbps fiber interface modules support 1 Gbps Copper SFP optics at 10 Mbps, 100Mbps
and 1Gbps speeds.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
shows the front panel of the BR-MLX-1GCx24-X interface module.
BR-MLX-1GCx24-X copper interface module front panel
LEDs to the left support the top ports, LEDs to the right support the bottom ports
24 1 Gbps RJ45 copper ports
describes the LEDs for the BR-MLX-1GCx24-X interface module.
BR-MLX-1GCx24-X copper module LEDs
Specifications".
BR-MLX-1GFx24-X
BR-MLX-1GFx24-X-ML
State Meaning
Solid green A link has been established.
Green blinking The port is transmitting and receiving packets.
Off No link exists and the port is not transmitting or
receiving packets.
1
Router modules
Chapter 8,
25