Interfaces Openvpn <Vtunx> Ipv6 Router-Advert - Brocade Communications Systems 5600 Reference Manual

interfaces openvpn <vtunx> ipv6 router-advert
interfaces openvpn <vtunx> ipv6 router-advert
Specifies the router advertisements (RA) to be sent from an OpenVPN interface.
Syntax
set interfaces openvpn vtunx ipv6 router-advert [ cur-hop-limit limit ] [ default-lifetime lifetime ] [
default-preference preference ] [ link-mtu mtu ] [ managed-flag state ] [ max-interval interval ] [ min-
interval interval ] [ other-config-flag state ] [ prefix ipv6net [ autonomous-flag state | on-link-flag
state | preferred-lifetime lifetime | valid-lifetime lifetime ] ] [ reachable-time time ] [ retrans-timer
time ] [ send-advert state ]
delete interfaces openvpn vtunx ipv6 router-advert [ cur-hop-limit ] [ default-lifetime ] [ default-
preference ] [ link-mtu ] [ managed-flag ] [ max-interval ] [ min-interval ] [ other-config-flag ] [
prefix ipv6net [ autonomous-flag | on-link-flag | preferred-lifetime | valid-lifetime ] ] [ reachable-
time ] [ retrans-timer ] [ send-advert ]
show interfaces openvpn vtunx ipv6 router-advert
Command Default Router advertisements are not sent on an interface.
Parameters
vtunx
cur-hope-limit limit
default-lifetime lifetime
default-preference preference
link-mtu mtu
managed-flag state
72
The identifier for the OpenVPN interface. This may be vtun0 to vtun x, where x
is a non-negative integer.
Limits the Hop Count field of the IP header for outgoing (unicast) IP packets.
This limit is placed in the Hop Count field. The limit ranges from 0 through 255.
The default limit is 64. A limit of 0 means that the limit is unspecified by the
router.
Specifies the lifetime, in seconds, associated with the default router. The
lifetime either is 0, which indicates the router is not a default router, or it ranges
from the interval specified in the max-interval argument through 9000 (18.2
hours). If not entered, the lifetime is three times the interval specified in the
max-interval argument.
Specifies the preference associated with the default router. The preference is
one of the following:
low: Makes the default router low preference.
medium: Makes the default router medium preference. The default preference
is medium.
high: Makes the default router high preference.
Specifies the MTU to be advertised for the link. The MTU either is 0 or it ranges
from 1280 through the maximum MTU for the type of link, as defined in RFC
2464. The default MTU is 0, which means the MTU is not specified in the router
advertisement message. That is because it is expected that the MTU is
configured directly on the interface itself and not for routing advertisements.
You can configure this option in cases where the link MTU is not well known.
If the MTU entered here does not match the MTU configured on the interface,
the system issues a warning but does not fail.
Specifies whether to use the administered protocol for address
autoconfiguration. The state is one of the following:
Brocade 5600 vRouter OpenVPN Reference Guide
53-1003719-03