Installing A Netiron Xmr 32000 Router In A Rack - Brocade Communications Systems MLX Series Hardware Installation Manual

3
Installing a NetIron XMR 32000 router
Follow these steps to remove the router from the shipping crate.
1. Position the crate so that you have access to the front and the rear. There must be enough
2. Use a power drill with Phillips and large flat-blade screwdriver attachments to remove the bolts
FIGURE 116
3. Remove the remaining bolts and screws that attach the bottom of the crate to the pallet.
4. Slide the sides, top, and back of the crate backwards as one unit until it clears the pallet.
5. Save the crate (including the shipping panel) in case the router needs to be shipped again.

Installing a NetIron XMR 32000 router in a rack

This section describes how to install a NetIron XMR 32000 router in a rack.
172
space to the rear of the pallet to slide and remove the crate.
and screws that hold the front shipping panel in place, as shown in
front shipping panel and set it aside.
Removing bolts and screws on the shipping crate
Brocade MLX Series and NetIron XMR Hardware Installation Guide
Figure 116. Remove the
53-1003821-01