Brocade Communications Systems MLX Series Hardware Installation Manual page 97

Follow these steps to install a power supply in a Brocade MLX-16 router.
1. Remove the power supply slot blank.
CAUTION
Empty power supply slots must be covered with slot blanks.
2. Remove the power supply from the packaging.
3. Insert the power supply into the slot, using the guides on either side of the slot.
FIGURE 56
1
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
Installing a power supply in a Brocade MLX-16 router
Power supply 2 Release latch
Installing a Brocade MLX-16 router
2
81