Pilz PMCprotego D.48 Operating Manual page 72

Function Description
Pin
4
5
6
7
8
9
10
11
12
Connector X11B
Operating Manual PMCprotego D.48, PMCprotego D.72
1001735-EN-04
Input/
output Default setting Description
Off Folge-InPos
PosReg 0
Off S_fehl
Off PosReg1
Off PosReg2
Off PosReg3
Off PosReg4
Off PosReg5
- 24 VDC
- I/O-GND
The start of each motion task within an automatic se-
quence of motion tasks is signalled by the inversion of
the output signal. When the first motion task is initiated,
the output registers a low signal. The message may be
varied via the parameters.
May only be set via commands
The output registers a low signal when it leaves the
preset drag error window.
Default: Software limit switch 1, output registers a high
signal
Default: Software limit switch 2, output registers a high
signal
May only be set via parameters
May only be set via parameters
May only be set via parameters
Supply voltage for digital outputs
Earth for the digital signals from the control system
72