Pilz PMCprotego D.48 Operating Manual page 12

Overview
}
Three-digit LED display for status and messages
Integrated safety
}
Device safety
–
–
–
}
Protection of personnel and plant
–
–
Communication interfaces
}
CANopen interface for
–
–
}
RS232 interface for parameter setting with the commissioning software
}
Ethernet-based interface
–
Card slot for SD card
} Card slot for SD card, for reading and writing parameters and firmware
Expansion cards
3 slots for expansion cards
}
Expansion cards for slot 1:
–
–
–
}
Expansion cards for slot 2:
–
–
–
Operating Manual PMCprotego D.48, PMCprotego D.72
1001735-EN-04
Safe electrical isolation between mains voltage/motor connection and control ele-
ment, in accordance with EN 61800-5-1
Soft start, overvoltage detection, short circuit protection, phase failure monitoring
Temperature monitoring of servo amplifier and motor (when using Pilz motors with
ready-made cables)
Safety function STO – Safe Torque Off
Single-channel without feedback: Up to PL d (Cat. 2) of EN ISO 13849-1 and
SIL CL 2 of EN/IEC 62061
Dual-channel with feedback: Up to PL e (Cat. 4) of EN ISO 13849-1 and SIL CL 3 of
EN/IEC 62061
Slot for safety card: Safety functions for safe operation of drive axes in accordance
with DIN IEC 61800-5-2, up to PL e (Cat. 4) of EN ISO 13849-1 and SIL CL 3 of
EN/IEC 62061
Connection to CAN bus systems
Parameters for several drives can be set via a servo amplifier's serial interface
EtherCAT
I/O-14/08
PROFIBUS DP
PROFINET
PMC expansion card PosI/O
PMC expansion card PosI/O-AIO
Fan controller, available only on request
12