Expansion Card Profinet; Expansion Card Fan Controller; Switch On/Switch Off Behaviour - Pilz PMCprotego D.48 Operating Manual

Function Description
4.4.5

Expansion card PROFINET

4.4.6

Expansion card Fan Controller

With the built-in fan controller, noise emissions are reduced. The expansion card must be
specified when the servo amplifier is ordered. It cannot be retrofitted and is only available
on request.
The expansion card is built into either slot 2 or 3 (see Type code).
Function
The fan switches on and off, depending on the ambient temperature, the heat sink temper-
ature or the brake power. In average temperature or performance ranges, the fan runs at
50 % of its rated speed. This reduces the noise emission considerably.
Monitoring
Ambient temperature
Heat sink temperature
4.5

Switch on/switch off behaviour

This section describes the behaviour of the servo amplifier when switching on and off. It ex-
plains the measures that are required to achieve compliance with the standards when a
stop or E-STOP is performed during operation.
ACTFAULT/STOPMODE
0
1 (default)
Operating Manual PMCprotego D.48, PMCprotego D.72
1001735-EN-04
INFORMATION
For information on the PROFINET expansion card, please refer to the oper-
ating manual "PROFINET for PMCtendo DD5 and PMCprotego D".
INFORMATION
An expansion card can be used in slot 1 if the fan controller is built into slot
2. No expansion cards can be used if the fan controller is built into slot 3.
Fan off
< 55 °C
< 58° C
INFORMATION
The servo amplifier's 24 VDC supply must be maintained even after a stop
or emergency stop.
The parameters ACTFAULT (reaction to fault) and STOPMODE (reaction to
ENABLE signal) define how the drive behaves when it is switched off.
Fan approx. 50 %
Approx. 58 °C
Approx. 68 °C
Behaviour*
Motor runs down in an uncontrolled manner
Motor is braked in a controlled manner
Fan on
> 65 °C
> 80 °C
79