Single Head (Xpj-1682Sr Only); Heater Control; Start Feed - MUTOH XpertJet XPJ-1641SR Training Manual

10. Advanced Operations
10.2. Menu 1: Setup (11/12)
Menu 1: Setup
Setup 26: Header Dump
Setting values
・ The data will be useful when contacting technical support.
・ Performing printing if the printer is connected to PC, the print settings of RIP soft you
are using are printed on data header.
Setup 27: Single Head (XPJ-1682SR Only)
Selects a print head for printing.（XPJ-1682SR Only）
can still print even if some of the print heads
malfunction.
However, in that case the printing speed will drop.
Setting values
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.90)
Dump data is not printed.
This is the initially set value.
Dump data is printed after the original image is
printed.
Prints only damp data.
"Data dot number" is not printed.
Prints the last header dump.
If no history is available, "No Print Data" will
appear on the front panel.
Select this setting to use all the print heads for
printing.
This is the initially set value.
Select this setting to use only print head 1 for
printing.
Select this setting to use only print head 2 for
printing.
Setup 28: Heater Control
Setting values
Setup 29: Start Feed
Setting values
With take-up system: if you want to set "Start Feed" to below 0, set "Page Gap" to
"Narrow".
If not, the Start Feed setting is not reflected properly.
Page. 94
To Table of Contents
cf. Operation Manual(Rev.01-p.91)
Choose the appropriate heater mode for your media
being loaded.
If the media cockling is visible on the print, you can
reduce it by selecting the appropriate heater mode.
If you are using the non-heat sensitive media,
choose the Normal mode.
This is the initially set value.
If you want to reduce time to start printing and
make media cockling less visible, choose the
Fixer mode.
If you are using the take-up unit and want to
make media cockling less visible without
reducing drying performance, choose the Dryer
mode.
You can change the margin setting between images.
・ Value greater than 0: The margin setting between
images will be wider than when setting "0".
・ Value equal to 0: The default margin setting
between images will be applied.
・ Value less than 0: The margin setting between
images will be smaller than when setting "0".
-10 mm to <0 mm> to 500.0 mm
<> indicates the initial value.
CONFIDENTIAL