Replacing Print Head [Xpj-1682Sr] - MUTOH XpertJet XPJ-1641SR Training Manual

8. Print head

8.4. Replacing print head [XPJ-1682SR] (1/2)

cf. Maintenance Manual(XPJ-1682SR: Rev.00-3.8.14.)
Replacing print head [XPJ-1682SR] (1/4)
Preparation:
・ Hex Wrench 2.5mm
・ Round nose Plyers
Maintenance Part
・ DG-49581: Print Head Assy (MS41)
DO NOT use anything other than above listed Print Head Assy.
Doing so may cause critical damage to the hardware and function.
[1] Discharge ink.
If ink remains in the path when replacing print
head, occasional ink drop may destroy electric
circuit of print head.
[2] Remove CR cover.
[3] Release carriage lock manually.
[4] Move carriage to the middle of platen.
[5] Release head FFC from clips on its path. (x4)
CSTM-XPJ16xxSR(E)_1.00
Replacing print head [XPJ-1682SR] (2/4)
[6] Remove head connector(s).
Turn head connector by 45 degree clockwise. Pull
out vertically
Do not turn counter-clockwise.
It may damage connector and cause ink leak.
[7] Place head connectors in plastic bag.
[2]
To prevent environment from contamination.
[8] Remove screw(s).
[9] Remove print head(s).
[4]
[5]
Page. 70
cf. Maintenance Manual(XPJ-1682SR: Rev.00-3.8.14.)
To Table of Contents
[6]
[7]
[8]
[8]
CONFIDENTIAL