Side Margin - MUTOH XpertJet XPJ-1641SR Training Manual

10. Advanced Operations
10.2. Menu 1: Setup (2/12)
Menu 1: Setup
Setup 2: Spitting
Pass Count menu
This is for setting the interval at which the print head
will carry out spitting operation.
The head will carry out spitting operation every time it
completes the number of passes that you set here.
Use
Setting values
If larger count is selected, the printing time will be faster, but it will increase
the chance of nozzle clogging.
In such a case, print quality cannot be guaranteed.
<Example of spitting operation>
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.76)
or to enter the value, and tap [Enter].
1 cnt/<2 cnt> to 999 cnt
<> indicates the initial value.
Setup 3: Side Margin
Setting values
When the "Spitting menu" is set to "On Media", the maximum printable media width
becomes 16 mm shorter.
Therefore, the side margins become the value that you have set in Side Margin menu
+8 mm.
Setup 4: Media Initial
Setting values
When "Media Initial menu" is set to "Off", set the media width of the current media in
Media Width menu.
Page. 85
To Table of Contents
cf. Operation Manual(Rev.01-p.77)
Set up the right and left margins (side margins) while
printing.
Use or to enter the value, and tap [Enter].
<5 mm> to 25 mm
<> indicates the initial value.
Sets whether to detect the media width while
initializing the media.
The media will not be detected.
Detect the media width and edge while
initializing the media.
Detect the media width while initializing the
media.
This is the initially set value.
CONFIDENTIAL