MUTOH XpertJet XPJ-1641SR Training Manual page 119

11. User Maintenance
11.13. Replacing the cleaning wiper (2/2)
Replacing consumable parts
Replacing the cleaning wiper
1. Step (2/3)
[5]
[6]
[7]
[8] Close the front cover.
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.135)
Remove the cleaning wiper.
・ Lift the cleaning wiper hook and release the
hook. Then, remove the cleaning wiper.
When removing the cleaning wiper, be
cautious of ink drops.
Used cleaning wiper should be put in a plastic bag,
etc, and dispose of it in compliance with local
ordinance and instructions of local authorities.
Follow the steps below to install new cleaning
wiper.
・ Slide the front side of the new cleaning wiper
into its slot.
・ Press the wiper hook down until it clicks into
place.
Do NOT touch the cleaning wiper rubber with
your bare hand.
If finger oil gets on the rubber, it will damage
the print head.
Close the maintenance cover.
Replacing the cleaning wiper
1. Step (3/3)
[9]
[10]
Page. 119
To Table of Contents
cf. Operation Manual(Rev.01-p.135)
Tap [Enter].
Tap [Home] to end the cleaning process.
CONFIDENTIAL