MUTOH XpertJet XPJ-1641SR Training Manual page 54

5. Unpacking and Initial Setup
5.9. Advanced settings (3/3)
Advanced settings
Changing holddown pressure using media feed lever
Steps (1/2)
[1]
[2]
[3] Push down the tab on the slider lock lever, then slide it to the front.
・ To reduce pressure, slide it to front until it clicks.
・ To cancel the pressure roller, fully slide it to the front until it clicks into place.
First, try to reduce or cancel the rollers on both edges of the media. It the problem
persists, reduce or cancel more rollers.
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.42)
Open the front cover.
(To cancel the individual pressure rollers) From
the front side of the printer, pull the media feed
lever towards you as much as possible to release
the pressure rollers.
(To set the slide lock lever to the Low position)
Set the media feed lever to the Normal position.
・ You cannot cancel the individual pressure rollers
unless you release the pressure rollers by the
media feed lever.
Changing holddown pressure using media feed lever
Steps (2/2)
[4]
[5]
[6] Perform media feed adjustment.
Page. 54
To Table of Contents
cf. Operation Manual(Rev.01-p.43)
(To cancel the individual pressure rollers) Push
the media feed lever back to the original position
to lock the pressure rollers.
Close the front cover.
CONFIDENTIAL