Fine Adjustment Pattern - MUTOH XpertJet XPJ-1641SR Training Manual

5. Unpacking and Initial Setup
5.8. Setting the Printing Precision (9/13)
Calibrating your printer
Print quality calibration

Fine adjustment pattern

・ Tap [Enter] to carry out printing.
For the Fine pattern, the same patterns will be printed repeatedly on both sides and
center of the media.
・ For Head 1, check the print results on both sides and center of the media and select
the number that looks most aligned between 1 and 7.
・ Pattern names such as "Pattern B1: 4" are shown on the display.
Use or to enter the number of the best-adjusted pattern, and tap [Enter].
・ In the case of the picture below, enter "6", so that the display reads "Pattern B1: 6".
Follow the same procedure to adjust print head 2 (XPJ-1682SR Only).
CSTM-XPJ16xxSR(E)_1.00
cf. Operation Manual(Rev.01-p.67)
Page.
Print quality calibration
Auto Adjustment Method
1. Select the adjustment pattern from "ALL", "Standard", or any specific pattern
between "Adjust Pattern A" and "Adjust Pattern F".
・ The selected adjustment pattern is printed.
・ The printer scans the print using the embedded color sensor, then automatically
corrects the dot placement.
2. Once successfully completed, the message "Auto Adjust Succeeded End->Enter" will
appear on the panel.
・ If failed, the message "Auto Adjust Failed End -> Enter" will appear on the panel.
Tap [Enter] to end the adjustment.
・ Try Auto Adjust again or perform Standard or Custom adjustment.
3. Tap [Enter] to exit the menu.
・ If failed in the middle of the calibration, the adjustment value for the pattern which
has been successfully calibrated will be saved in the printer, but the adjustment
value for the pattern which has been failed to calibrate or has not been calibrated yet
will not be saved in the printer.
・ Warm up the heater before printing the Confirm and Adjustment patterns.
"Skip Heater Warm Up? No" is displayed on the front panel.
・ You can start printing while the printer is warming up.
・ If print defects (like banding or grainy look) still appear on the print, try an auto
calibration again, or go to "Adjust Print1/ Standard" or "Adjust Print2/ Custom" to
perform calibration.
・ If a roll media starts to cockle during calibration, load the media again.
While "Warming Up" is displayed, do not touch Media guide.
You could burn yourself.
48
To Table of Contents
cf. Operation Manual(Rev.01-p.68)
CONFIDENTIAL